If there is more than one partition on the USB drive, it should use the first one.

The USB drive that is intended to perform STB SW update must comply with the next requirements: USB drive requirements and troubleshooting Requirements Your browser does not support the HTML5 video element Do not turn off STB or torn down the network connection until the end of the update. STB will be rebooted automatically after update completing. The status of updating is displayed by the progress bar and comments.

Choose Update (F1) to start the update.

Choose Verify (ОК). If verification of connection to the server is successful, then you'll see information about the availability of new versions of the software.

Go to Settings ⇒ System settings (or press Setup on RC).

In factory image, the following updating address is used: ( where model is a number value of STB model: 322, 324, 349 or 351) STB will be rebooted automatically after update completing.

In the opened window Software autoupdatechoose the list of New versions by pressing OK - the latest available version is located at the top of the list.

In the opened window choose Update manually ( F2 on RC).

Open Settings menu of the Embedded portal.

When STB runs under control the standard software image (factory made image: public or factory image), STB software updates to the last stable version (factory image) located on the manufacturer's server: : ( - number of STB model - 322, 324, 349, 351).

Stb manager software download